EvoX Camshaft Position to Pressure Sensor Harness

Running a MIVEC delete on your EvoX with Aftermarket ECU? As long as you are not using the exhaust cam sensor you can utilize the open input with this harness to read an additional pressure sensor. 
 
Included in the Kit:
Labeled Motorsports Grade Harness - Milspec Tefzel Wiring
Harness Constructed IN-HOUSE at our Texas Location
FULL COLOR Installation wire routing and connector instructions 
ECU Data to easily setup the new sensor
 
Wiring Options:
-Standard install routes damper tank near driver's side of USDM vehicle. Harness will reach ~16" from OEM ECU Location, allowing coverage of driver's side engine bay sensor location. 
 
Haltech EvoX Kits: Changes SPI 2 to a new usable input for an additional pressure sensor.
 
 
 
 
 
 
 
 
 
 
 
 
Kozmic components carry a 6 month limited warranty from time of purchase, sensors and electronics are under manufacturer warranty. IMPORTANT EMISSIONS NOTICE:In many states, it is unlawful to tamper with your vehicle's emissions equipment. Kozmic and Haltech products are designed and sold for sanctioned off-road/competition non-emissions controlled vehicles only and may never be used on a public road or highway. Using Haltech products for street/road use on public roads or highways is prohibited by law unless a specific regulatory exemption exists (more information can be found on the SEMA Action Network website www.semasan.com/emissions for state by state details in the USA). It is the responsibility of the installer and/or user of this product to ensure compliance with all applicable local and federal laws and regulations. Please check with your local vehicle authority before purchasing, using or installing any Haltech product.