Crankcase Pressure Sensor Kit

Built motor and ALOT of boost?!?! Are you sure your catch can system is adequate? Now you can be 100% confident or be ready to make changes now that you can log the pressure in the engine crankcase system with this kit. 
 
Simply weld the aluminum bung on the valve cover or the stainless bung on your dip stick tube, route the wiring to the plug and play expansion connector and enable in the ECU!
 
Included in the Kit:
Stainless Steel 3.5 Bar MAP Sensor - Use a map sensor to see vacuum readings as well. 
Aluminum or Stainless Steel Weld On Bung
Labeled Motorsports Grade Harness - Milspec Tefzel Wiring - Terminated ready to install into expansion connector.
Harness Constructed IN-HOUSE at our Texas Location
FULL COLOR Installation routing and wiring instructions 
ECU Data to easily setup the new sensor
 
Required Inputs for Operation:
Crankcase Pressure - x1 Analog OR SPI Input
 
 
 
 
 
 
 
 
 
 
 
Kozmic components carry a 6 month limited warranty from time of purchase, sensors and electronics are under manufacturer warranty. IMPORTANT EMISSIONS NOTICE:In many states, it is unlawful to tamper with your vehicle's emissions equipment. Kozmic and Haltech products are designed and sold for sanctioned off-road/competition non-emissions controlled vehicles only and may never be used on a public road or highway. Using Haltech products for street/road use on public roads or highways is prohibited by law unless a specific regulatory exemption exists (more information can be found on the SEMA Action Network website www.semasan.com/emissions for state by state details in the USA). It is the responsibility of the installer and/or user of this product to ensure compliance with all applicable local and federal laws and regulations. Please check with your local vehicle authority before purchasing, using or installing any Haltech product.